- Description
- Additional information
Description
Water Trap Tee
Our new Water Trap Tee solves the on-going problem of moisture in a compressed air system and provides the easy alternative to the need to install “Goose Necks”. The ingenious inside arrangement of the fitting allows air to flow, with minimum head loss from the main to take-off point without allowing water to follow. The moisture is retained in the line to be drawn off at some suitable location.
Installation
It is of vital importance for the correct function of the Water Trap Tee that the air supply within which the Tee is installed is near horizontal and that the outlet port faces vertically downwards. Markings to indicate correct orientation have been molded onto the body to assist installation.
Water Trap Tee Converter
The Water Trap Tee Converter is a simple, convenient way of converting a standard 28mm Tee to a Water Trap Tee. This will stop condensing water from entering the vertical take off spur. The air supply needs to be installed with the correct fall and water drain points regularly vented. To Assemble Using our 28mm aluminum pipe, the pipe must be cut square and be free of burrs. Press the shorter spigot into the pipe. The fit on aluminum pipe will be loose, this will not affect the function. Push the pipe and converter up to the pipe stop of the center leg of the tee. Turn the screw cap approx 1/4 turn to lock the pipe in position
Additional information
Diameter | |
---|---|
Fitting | Tee (22mm), Tee Converter (28mm) |